Whether you are creating photo ID badges, visitor cards, membership cards, or something else, we know you are going to get the perfect design. ST may be rolling out the drivers automatically, but I didn't want to take the chance in my devices not working properly once the switch was made. ID Maker 3.0 provides advanced features and functionality coupled with the best user interface in the ID software industry. ![]() There are plenty of articles on the Smartthings Community page as well as youtube videos showing moving to Edge drivers. I went through and took a screenshot of the routines on a specific device I was removing, so I could go through and remove the device from that routine, and re-add it once it was connected to an Edge driver. Be sure to notate if there are any routines assigned to a device. If you have a driver installed that works with a specific device, it will select that Edge driver automatically. Once you have the driver installed, you'll need to remove each device from your hub, then re-add it. Most users won't run into this situation. Take note, only 50 drivers can be installed on your hub at one time. Once you're enrolled in a channel, you can view the available drivers they have that can be installed on your Hub. You can enroll your hub into these channels. ![]() How many devices do you have connected to your ST hub? What I did was list all the different type of devices I have (ST door sensors, Innr RGB bulbs, Aeotec Nano switches, etc.) and search to see if there are Edge drivers being created for them.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |